SERVING THE DFW METROPLEX “Family owned and operated since 1972” St. Lic. # TACLA019484E 214-742-7252 Glossary Dampers HVAC term for controls that vary airflow through an air outlet, inlet, or duct. A damper position may be immovable, manually adjustable or part of an automated control system. Degree Day A unit for measuring the extent that the outdoor daily average temperature (the mean of the maximum and minimum daily dry-bulb temperatures) falls below (in the case of heating, see Heating Degree Day), or falls above (in the case of cooling, see Cooling Degree Day) an assumed base temperature, normally taken as 65 degrees Fahrenheit, unless otherwise stated. One degree day is counted for each degree below (for heating) or above (in the case of cooling) the base, for each calendar day on which the temperature goes below or above the base. Degree Hour The product of 1 hour, and usually the number of degrees Fahrenheit the hourly mean temperature is above a base point (usually 65 degrees Fahrenheit); used in roughly estimating or measuring the cooling load in cases where processes heat, heat from building occupants, and humidity are relatively unimportant compared to the dry-bulb temperature. Dehumidifier A device for reducing the level of humidity in a room or home. Demand (tankless) Water Heater A type of water heater that has no storage tank thus eliminating storage tank stand-by losses. Cold water travels through a pipe into the unit, and either a gas burner or an electric element heats the water only when needed. Diffusers and Grilles Components of the ventilation system that distribute and return air to promote air circulation in the occupied space. As used in this document, supply air enters a space through a diffuser or vent and return air leaves a space through a grille. Direct Water Heater A type of water heater in which heated water is stored within the tank. Hot water is released from the top of the tank when a hot water faucet is turned. This water is replaced with cold water that flows into the tank and down to just above the bottom plate under which are the burners. Draft A column of burning combustion gases that are so hot and strong that the heat is lost up the chimney before it can be transferred to the house. A draft brings air to the fire to help keep it burning. Draft Diverter A door-like device located at the mouth of a fireplace chimney flue for controlling the direction and flow of the draft in the fireplace as well as the amount of oxygen that the fire receives. Draft Hood A device built into or installed above a combustion appliance to assure the escape of combustion byproducts, to prevent backdrafting of the appliance, or to neutralize the effects of the stack action of the chimney or vent on the operation of the appliance. Dual Duct System An air conditioning system that has two ducts, one is heated and the other is cooled, so that air of the correct temperature is provided by mixing varying amounts of air from each duct. Duct Fan HVAC term for an axial flow fan mounted in a section of duct to move conditioned air. Duct(s) The round or rectangular tube(s), generally constructed of sheet metal, fiberglass board, or a flexible plastic- and-wire composite, located within a wall, floor, and ceiling that distributes heated or cooled air in buildings. Air Conditioning and Heating Terms Sala Air Conditioning has been serving the DFW area since 1972, providing commercial and residential heating and air conditioning. (Parts, Sales, Service, Installations, and Repairs) Home | Products | Services | Coupons | Contracting  | Contact  | Employment  | About Us   | Sitemap Air Conditioning and Heating Terms A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z D A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z D