Before You Call
Before calling for HVAC emergency service, please read the tips below. It may prevent a service call or help us diagnose your problem quicker.
Air Conditioner – No Cooling
- Check the settings on your thermostat. Make sure the temperature control selector is set below the current room temperature, and the system switch is on the COOL or AUTO position. The fan switch should be set to ON for continuous airflow or AUTO if you want the blower to operate only while the air conditioner is operating.
- Try to get the air conditioner to turn on by lowering the thermostat to its lowest temperature setting.
- If the air flow out of your registers seems low, check the air filter. An extremely dirty air filter can block air flow. (Click Here – Order Your Air Filters Today)
- Make sure all registers are open and not obstructed.
- Check the power disconnect switch by each unit (outdoor and indoor).
- Check the fuse/breaker at the electrical panel for both the outdoor and indoor unit.
- If the problem persists, please call us.
Heat Pump – No Cooling
- Check the settings on your thermostat. Make sure the temperature control selector is set below the current room temperature, and the system switch is on the COOL or AUTO position. The fan switch should be set to ON for continuous airflow or AUTO if you want the blower to operate only while the heat pump is operating.
- Try to get the air conditioner to turn on by lowering the thermostat to its lowest temperature setting.
- If the air flow out of your registers seems low, check the air filter. An extremely dirty air filter can block air flow.
- Make sure all registers are open and not obstructed.
- Check the power disconnect switch by each unit (outdoor and indoor).
- Check the fuse/breaker at the electrical panel for both the outdoor and indoor unit.
- If the problem persists, please call us.
Gas Furnace – No Heat
- Check the settings on your thermostat. Make sure the temperature control selector is set above the current room temperature, and the system switch is on the HEAT or AUTO position. The fan switch should be set to ON for continuous airflow or AUTO if you want the blower to operate only while the furnace is operating.
- Try to get the air conditioner to turn on by lowering the thermostat to its lowest temperature setting.
- If the air flow out of your registers seems low, check the air filter. An extremely dirty air filter can block air flow.
- Make sure all registers are open and not obstructed.
- Check the power disconnect switch by each unit (outdoor and indoor).
- Check the fuse/breaker at the electrical panel for both the outdoor and indoor unit.
- If the problem persists, please call us.
